Rod cutting machine Highlights

(1) Before using Rod cutting machine , to check the blade is firmly installed, the gap is appropriate, transmission system, the relative moving part. Points lubrication is good, the last load test run, after confirmation before the official start of operations.
(2) the level of the fixed and movable blade gap should be maintained 0.5 ~ 1.0 mm, if the level of the gap is too large reinforced ends of the cut prone horseshoe. The amount of overlap of the two blades to be determined in accordance with the cut rebar diameter. Usually when cutting diameter less than 20 mm, blade vertical clearance is 1 ~ 2 mm, cut off 20 mm diameter greater than or equal to about 5mm. Increase or decrease the fixed blade clearance adjustable pad behind the blade.
(3) When cutting steel, the operator should hand grip bars, and other activities when the return blade into steel, reinforced to prevent the end of the swing or pop wounding.
(4) lead to be cut to the cut steel vertical and flat, the length of use pliers material into short steel blade when cutting 300mm or less, are not allowed direct hand feeding.
(5) exceeds a predetermined cutter diameter steel or chemical components in the steel over steel, steel and other burning red are not allowed off the plane.
(6) Rod cutting machine during operation, do not touch the cleaning blade above the dust accumulation, debris and found the sound is not working properly, the blade poor adhesion, etc., should immediately stop inspection, repair, until after commissioning, They are allowed to continue to use.
(7) Before using the hydraulic Rod cutting machine , to check the oil level and the motor rotation direction. Methods: Pine oil valve open, no-load operation 2min, exclude cylinder air, then tighten.
(8)Rod cutting machine handheld hydraulic  when in use, hands should be steady cutting machine, and wear insulated gloves.